Moska
9th October 2009, 03:32 PM
G'day guys.
The name's Moska, 22, from the eastern suburbs of Vic.
I'm in to my Subaru's in a big way, love em all to death.
I'm one of 4 owners of the Vic based cruise club MelbCityCruisers which has been a good hobby.
This is me, if you live anywhere near me, you've probably seen me before :P
http://photos-a.ak.fbcdn.net/hphotos-ak-snc1/hs257.snc1/10427_171915069114_550789114_3695656_5047417_n.jpg
I'm the guy on the right! HAIR!
So then there's the cars!
http://photos-d.ak.fbcdn.net/photos-ak-snc1/v2702/156/82/692481359/n692481359_2192643_6749265.jpg
That's the Gen1, I drive her around a bit but it's more my girlfriends' car.
1992 RX
EJ22 NA
Auto
Diff Back
That's about all.
Then there's my pride and joy,
http://photos-d.ak.fbcdn.net/hphotos-ak-snc1/hs129.snc1/5532_1199552107516_1189927780_30621747_7062963_n.j pg
http://photos-e.ak.fbcdn.net/hphotos-ak-snc1/hs149.snc1/5532_1199552147517_1189927780_30621748_1875483_n.j pg
http://photos-a.ak.fbcdn.net/hphotos-ak-snc1/hs098.snc1/4732_1175129736972_1189927780_30525728_6255062_n.j pg
MY98 WRX
EJ20
5Spd
VF30
HDI FMIC
GFB Hybrid BOV
3" MRT TBE
HDI Dual Stage Electronic Boost Controller
Front and rear strut braces
Front and rear Whiteline HD swaybars and links
BC BR Coilovers
Power FC
Recently spun a big end bearing whilst the PFC was being tuned for the first time, made 170kwatw off the street pre-PFC.
In the works now is:
EJ207 Forged bottom end
STI injectors
Walbro 550hp Fuel Pump
Then there's the new GenII
1997 RX
1997 STI Motor
EJ 207 bottom end
Wiseco Forged Pistons and H-beam rods
Balanced crank
2000 STI 5spd and Diff
Trust FMIC
3" TBE
VF22
Apexi BOV
Apexi Boost Guage
Greddy Wideband AFR Guage
Blitz DTT DTCII
UniChip
HKS lowered springs
Apexi Adjustable dampers
Nothing else I've noticed yet, I did notice last night that it has the twinscroll sump but not the twinscroll headers or turbo :(
I purchased this car last week undriveable due to a failed slave cylinder, after replacing that I found the clutch fork had way too much play, after dropping the box last night we found the release bearing was detached from the pressure plate and the bearing was smashed to bits. We snapped the old one off my old rexie pressure plate and viola, it drove under it's own power. Needs a new front bar, boot and bonnet but otherwise, she's gonna be a devil once she's on the road.
I'm going full sleeper spec with this one, RX bonnet, spray the FMIC black, quiet down the exhaust, take off the 17's and chuck some stockies on with hubcaps, move the guages so you can't see em and no one would think twice that this car was fast :D
I was referred here by my mate Josh (wherever you are :D), he said you guys were a good bunch and were normal unlike some other clubs out there :P
Do you guys have meets or cruises or anything like that? I'd love to come along and meet some of ya :D
The name's Moska, 22, from the eastern suburbs of Vic.
I'm in to my Subaru's in a big way, love em all to death.
I'm one of 4 owners of the Vic based cruise club MelbCityCruisers which has been a good hobby.
This is me, if you live anywhere near me, you've probably seen me before :P
http://photos-a.ak.fbcdn.net/hphotos-ak-snc1/hs257.snc1/10427_171915069114_550789114_3695656_5047417_n.jpg
I'm the guy on the right! HAIR!
So then there's the cars!
http://photos-d.ak.fbcdn.net/photos-ak-snc1/v2702/156/82/692481359/n692481359_2192643_6749265.jpg
That's the Gen1, I drive her around a bit but it's more my girlfriends' car.
1992 RX
EJ22 NA
Auto
Diff Back
That's about all.
Then there's my pride and joy,
http://photos-d.ak.fbcdn.net/hphotos-ak-snc1/hs129.snc1/5532_1199552107516_1189927780_30621747_7062963_n.j pg
http://photos-e.ak.fbcdn.net/hphotos-ak-snc1/hs149.snc1/5532_1199552147517_1189927780_30621748_1875483_n.j pg
http://photos-a.ak.fbcdn.net/hphotos-ak-snc1/hs098.snc1/4732_1175129736972_1189927780_30525728_6255062_n.j pg
MY98 WRX
EJ20
5Spd
VF30
HDI FMIC
GFB Hybrid BOV
3" MRT TBE
HDI Dual Stage Electronic Boost Controller
Front and rear strut braces
Front and rear Whiteline HD swaybars and links
BC BR Coilovers
Power FC
Recently spun a big end bearing whilst the PFC was being tuned for the first time, made 170kwatw off the street pre-PFC.
In the works now is:
EJ207 Forged bottom end
STI injectors
Walbro 550hp Fuel Pump
Then there's the new GenII
1997 RX
1997 STI Motor
EJ 207 bottom end
Wiseco Forged Pistons and H-beam rods
Balanced crank
2000 STI 5spd and Diff
Trust FMIC
3" TBE
VF22
Apexi BOV
Apexi Boost Guage
Greddy Wideband AFR Guage
Blitz DTT DTCII
UniChip
HKS lowered springs
Apexi Adjustable dampers
Nothing else I've noticed yet, I did notice last night that it has the twinscroll sump but not the twinscroll headers or turbo :(
I purchased this car last week undriveable due to a failed slave cylinder, after replacing that I found the clutch fork had way too much play, after dropping the box last night we found the release bearing was detached from the pressure plate and the bearing was smashed to bits. We snapped the old one off my old rexie pressure plate and viola, it drove under it's own power. Needs a new front bar, boot and bonnet but otherwise, she's gonna be a devil once she's on the road.
I'm going full sleeper spec with this one, RX bonnet, spray the FMIC black, quiet down the exhaust, take off the 17's and chuck some stockies on with hubcaps, move the guages so you can't see em and no one would think twice that this car was fast :D
I was referred here by my mate Josh (wherever you are :D), he said you guys were a good bunch and were normal unlike some other clubs out there :P
Do you guys have meets or cruises or anything like that? I'd love to come along and meet some of ya :D